tape casting meaning in English
带状铸材
Examples
- By optimizing the process parameters , 1l prescription was decided to use in tape casting process
通过工艺参数的优化，确定将1l配方用作流延成型95氧化铝瓷的粉料配方。 - The multilayer composites ( cof3 # ) were prepared at 900 c by cofiring jd ferroelectrics and ty ferrite using tape casting processes
7h时，差别因子小于1 ，继续增加保温时间时，界面处晶粒尺寸将小于远离界面区域的晶粒尺寸。 - The main intention of this study is to investigate 95 alumina substrates by tape casting process , which will be used as ceramic packages in kinds of integrate circuit ( ic ) . high bending strength and fine surface were required as the basic properties of ceramic substrates . in this thesis , based on the research of the tape casting used in ceramic substrates at home and abroad
本文综述了国内外研究现状，着重研究细晶氧化铝的制备和流延工艺参数的控制，以及细晶95al2o3瓷的制备，研究al2o3原料（包括种类和粒度） 、掺杂改性剂、流延浆料、有机配方等对95al2o3瓷基片性能的影响，获得最佳流延配方，流延基片综合性能良好，成功制备了细晶氧化铝瓷基板。 - But its sintering temperature is so high that it cannot be sintered under 1000 with low melting point electrode materials like ag , cu etc . presently investigations about this material are mainly via glass - ceramic technique to decrease the sintering temperature and the dielectric loss is high . for the first time , this investigation manufacture a casio 3 system low dielectric and high frequency microwave dielectric ceramic via tape casting with basic material altered and additives doped
本文以casio _ 3体系为研究对象，首先对casio _ 3体系进行改性，并首次采用li _ 2o和bi _ 2o _ 3作为烧结助剂，降低体系烧结温度，在此基础上，采用catio _ 3调节陶瓷的频率温度系数，制备出微波介电性能优良的具有工业应用价值的casio _ 3系ltcc低介高频微波介质陶瓷。 - In tape casting process , the mixture of xylene and propanol were used as the solvent of the slurry . the more suitable dispersing agent - s80 was selected as the suitable dispersing agent in the slurry to fit the solvent after the preparatory experiment . the influence of alumina powder content , the ratio of plasticizer and binder not only on the viscosity of the slurry but also on the pliability of green tape were investigated ,
二甲苯和异丙醇混合液作溶剂，选择适合溶剂的分散剂，并研究了氧化铝固含量、塑性剂与粘结剂的比值（ r ）对浆料粘度的影响，以及氧化铝固含量、 r值和复合塑性剂的不同配比对素坯性能的影响。